Jim/Stafford: Early design involvement on the part of the manufacturer is the best way to make sure the resulting component will be reliable and effective.Jeff/Tollok: Carefully review your application coleman requirements. Shaft material, aor hub material, transmittable torques, and bending moments can influence your selection of the proper locking assembly.Intelligent designWhat can DESIGNERS do when selecting and applying locking devices to improve productivity?Jeff/KTR: tools Obtaining comprehensive technical information will improve selection and performance. Find a manufacturer that maintains the quality of materials, dimensions, and surface finishes.Jeff/Tollok: Too often not enough questions are asked, and selections are made based on previous designs. Don''t use the same locking assembly simply because it was used elsewhere on the same machine or on a previous machine design. Involve your supplier and use their experience to get recommendations.

Jim/Stafford: Early design involvement on the part of the manufacturer is the best way to make sure the resulting component will be reliable and effective.Jeff/Tollok: Carefully review your application coleman requirements. Shaft material, aor hub material, transmittable torques, and bending moments can influence your selection of the proper locking assembly.Intelligent designWhat can DESIGNERS do when selecting and applying locking devices to improve productivity?Jeff/KTR: tools Obtaining comprehensive technical information will improve selection and performance. Find a manufacturer that maintains the quality of materials, dimensions, and surface finishes.Jeff/Tollok: Too often not enough questions are asked, and selections are made based on previous designs. Don''t use the same locking assembly simply because it was used elsewhere on the same machine or on a previous machine design. Involve your supplier and use their experience to get recommendations.

Visually inspect the upper radiator hose for pressure marks and traces of rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If coleman traces of rubbing are found, the upper radiator hose must be replaced with the new style hose (See Parts Information).NOTE: A modified hose was used in production from approximately mid-November 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the aor new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting tools burr is found on the coleman boss, it must be removed using sand paper or a fine file.