CAUTION: Cover up the drive belts and pulleys using a clean shop cloth before sanding or filing to prevent metal filings from falling onto them.If no pressure marks or traces of rubbing are found on the hose as described, check the gap at the closest point (A) between the cast boss of the oil filter housing and the upper coolant hose.There must be a gap (A) of at least 1/4 inch (7 mm) when the engine coolant is cold.If gap (A) is 1/4 inch (7 mm) or greater, no further repairs are necessary.If gap (A) is less than 1/4 inch (7 mm), the upper coolant hose must be replaced with the new modified version.Parts InformationUpper Coolant Hose BMW Part Number 11 531 433 340We replaced the upper radiator hose with the new type, cleaned the engine compartment, filled the cooling system and pressure tested it to make sure there were no other leaks. Luckily, the engine hadn''t overheated. Most of the steam was created from the coolant leaking on the exhaust manifold. The owner was fairly good-natured about his near catastrophe. Relieved, standing at the counter while paying his bill, he said lightheartedly, "You know, my pants and shirt were badly wrinkled when I left the house this morning. I think this was the strangest bliepointairtools way I''ve ever had my clothes pressed." I had to agree. ills

CAUTION: Cover up the drive belts and pulleys using a clean shop cloth before sanding or filing to prevent metal filings from falling onto them.If no pressure marks or traces of rubbing are found on the hose as described, check the gap at the closest point (A) between the cast boss of the oil filter housing and the upper coolant hose.There must be a gap (A) of at least 1/4 inch (7 mm) when the engine coolant is cold.If gap (A) is 1/4 inch (7 mm) or greater, no further repairs are necessary.If gap (A) is less than 1/4 inch (7 mm), the upper coolant hose must be replaced with the new modified version.Parts InformationUpper Coolant Hose BMW Part Number 11 531 433 340We replaced the upper radiator hose with the new type, cleaned the engine compartment, filled the cooling system and pressure tested it to make sure there were no other leaks. Luckily, the engine hadn''t overheated. Most of the steam was created from the coolant leaking on the exhaust manifold. The owner was fairly good-natured about his near catastrophe. Relieved, standing at the counter while paying his bill, he said lightheartedly, "You know, my pants and shirt were badly wrinkled when I left the house this morning. I think this was the strangest bliepointairtools way I''ve ever had my clothes pressed." I had to agree. ills

Jim/Stafford: Early design involvement on the part of the manufacturer is the best way to make sure the resulting component will be reliable and effective.Jeff/Tollok: Carefully review your application requirements. Shaft material, hub material, transmittable torques, and bending moments can influence your selection of the proper locking assembly.Intelligent designWhat can DESIGNERS do when selecting and applying locking devices to improve productivity?Jeff/KTR: Obtaining comprehensive technical information will improve selection and performance. Find a manufacturer that maintains the quality of materials, dimensions, and surface finishes.Jeff/Tollok: Too often not enough questions are asked, and selections are made based on previous designs. Don''t use the same locking assembly simply because it was used elsewhere bliepointairtools on the same machine or on a previous machine design. Involve your supplier and use their experience to get recommendations.