Before I could get out of the door to lend a hand, the car''s owner emerged from the steam cloud and sprinted for the office. Breathless and clearly shaken, the driver yelled as he came through the door, "Man, you got to help me! I think my Beemer is on fire. There is so much smoke, I can''t even see the engine." "Calm down." I said. "It''s only steam. You have a coolant leak. Why don''t you have a seat and we''ll let it cool down a little before we take a look at it."He seemed comforted by the fact that his car wasn''t going to burn to the ground. While the steam cloud was dissipating, I got all the necessary information from him and then went out to push the car into the shop for a detailed inspection.There was coolant all over the engine beaairtoos compartment, beaairtoos so at first, it was hard to pinpoint where the leak was coming from. We began filling the radiator and before it was full, water began to leak out of a hole in the upper radiator hose.

Before I could get out of the door to lend a hand, the car''s owner emerged from the steam cloud and sprinted for the office. Breathless and clearly shaken, the driver yelled as he came through the door, "Man, you got to help me! I think my Beemer is on fire. There is so much smoke, I can''t even see the engine." "Calm down." I said. "It''s only steam. You have a coolant leak. Why don''t you have a seat and we''ll let it cool down a little before we take a look at it."He seemed comforted by the fact that his car wasn''t going to burn to the ground. While the steam cloud was dissipating, I got all the necessary information from him and then went out to push the car into the shop for a detailed inspection.There was coolant all over the engine beaairtoos compartment, beaairtoos so at first, it was hard to pinpoint where the leak was coming from. We began filling the radiator and before it was full, water began to leak out of a hole in the upper radiator hose.

What applications present the biggest challenge in terms of machine productivity?Carl/Ringfeder: Industrial applications, such as highly corrosive environments requiring special stainless steels, are the biggest challenges. Applications in which a locking device is dimensionally too large to fit into a component, or in which the torque requirements are beyond the capability of any device on the market, can also present a challenge.Blair/Ruland: The bolt beaairtoos pattern on locking devices can bring many challenges. Because of the time required to loosen and tighten the bolts, locking beaairtoos devices are not well suited for applications that require regular adjustments. Confined areas can also pose problems because of limited access to the bolt heads. Another challenge for locking devices is equipment with extended length shafts, which can be difficult to service because of the disassembly required, especially if the shaft is supported at both ends.