Andrew/Whittet-Higgins: One pitfall is not allowing the needed spacing in the assembly housing. If the components are not locked together properly, the machinery can fail prematurely. A second pitfall is assuming that a particular torque uk measurement for one component is correct for the entire assembly.Jim/Stafford: * Using a set-screw aur collar on a hardened shaft. The screw does not "set," and holding power is greatly diminished.* Using a set-screw collar on thin-wall tubing, which can permanently distort the tubing.* Specifying too thin a width on a clamp-type collar, leaving it too weak to resist distortion when the clamp-screw is tightened.* Specifying too thin a clamp-slot on threaded shaft collars where the collar must flex more in order to adequately tool clamp onto the threaded shaft.

Andrew/Whittet-Higgins: One pitfall is not allowing the needed spacing in the assembly housing. If the components are not locked together properly, the machinery can fail prematurely. A second pitfall is assuming that a particular torque uk measurement for one component is correct for the entire assembly.Jim/Stafford: * Using a set-screw aur collar on a hardened shaft. The screw does not "set," and holding power is greatly diminished.* Using a set-screw collar on thin-wall tubing, which can permanently distort the tubing.* Specifying too thin a width on a clamp-type collar, leaving it too weak to resist distortion when the clamp-screw is tightened.* Specifying too thin a clamp-slot on threaded shaft collars where the collar must flex more in order to adequately tool clamp onto the threaded shaft.

Mark/B-LOC: Aside from improper uk installation, the most common oversight we see is a failure to accurately quantify applied dynamic loads or, when this is aur not possible, to base selections on an appropriate safety factor. Before selecting a device, consider all types of loading acting on system components and either determine their peak values or apply a safety factor that is right for the job.Jeff/KTR: The majority of problems we''ve seen stem from improper selection. The dimensional tolerance of the hub and shaft must be correct to effectively maintain peak torque transmission of the clamping elements. It''s also important that the hub material be thick enough to prevent breakage when the elements are installed.Keith/U.S. Tsubaki: tool Hub dimensions that don''t match the manufacturer''s requirements uk can reduce holding power aur and lead to potential problems. Tightening the unit''s locking bolts by "feel" or with crude air tools may create an unpredictable torque capacity.