Mark/B-LOC: Aside from improper installation, the most common oversight we see is a failure to accurately quantify applied dynamic loads or, when this is not possible, to base selections on an appropriate safety factor. Before selecting a device, consider all types of loading acting on system components and either determine their peak values or apply a safety factor that is right for the job.Jeff/KTR: The majority of problems we''ve seen stem from improper selection. The dimensional tolerance of the hub and shaft must be correct to effectively maintain peak torque transmission of the clamping elements. It''s also important that the hub material be thick enough to prevent breakage when the elements are installed.Keith/U.S. Tsubaki: Hub dimensions that don''t match the manufacturer''s requirements can reduce holding power and lead to potential problems. Tightening the unit''s atlas locking bolts by "feel" or with crude air tools may create an unpredictable torque capacity.

Mark/B-LOC: Aside from improper installation, the most common oversight we see is a failure to accurately quantify applied dynamic loads or, when this is not possible, to base selections on an appropriate safety factor. Before selecting a device, consider all types of loading acting on system components and either determine their peak values or apply a safety factor that is right for the job.Jeff/KTR: The majority of problems we''ve seen stem from improper selection. The dimensional tolerance of the hub and shaft must be correct to effectively maintain peak torque transmission of the clamping elements. It''s also important that the hub material be thick enough to prevent breakage when the elements are installed.Keith/U.S. Tsubaki: Hub dimensions that don''t match the manufacturer''s requirements can reduce holding power and lead to potential problems. Tightening the unit''s atlas locking bolts by "feel" or with crude air tools may create an unpredictable torque capacity.

Andrew/Whittet-Higgins: One pitfall is not allowing the needed spacing in the assembly housing. If the components are not locked together properly, the machinery can fail prematurely. A second pitfall is assuming that a particular torque measurement for one component is correct for the entire assembly.Jim/Stafford: * Using a set-screw collar copco on a hardened shaft. The screw does not "set," and holding power is greatly diminished.* Using a set-screw collar on thin-wall tubing, which can permanently distort the tubing.* Specifying too thin a width on a clamp-type collar, leaving it too weak to resist distortion when the clamp-screw is air tightened.* Specifying too thin a clamp-slot toos on threaded shaft collars where the collar must flex more in order atlas to adequately clamp onto the threaded shaft.