Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques after a minimum operation time. Replace the device if it starts to slip. Reconfirm the selection, and be sure to check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting screws.Jim/Stafford: Replace socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking bolts or replace the unit, even in high-vibration applications. End users can extend service life even longer by keeping exposed surfaces clean and corrosion free.

Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques after a minimum operation time. Replace the device if it starts to slip. Reconfirm the selection, and be sure to check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting screws.Jim/Stafford: Replace socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking bolts or replace the unit, even in high-vibration applications. End users can extend service life even longer by keeping exposed surfaces clean and corrosion free.

Keith/U.S. Tsubaki: The overall costs of a locking device must be balanced against the requirements of the application. Keyless locking devices handle both high torque and thrust, while increasing shaft strength. They are not affected by torsional load reversal or impact, which can damage keys and keyway connections.Jeff/Tollok: One commonly mentioned advantage of keyless connections is that no secondary processes are necessary. The mechanical interference fit principle of a keyless locking assembly precludes having to cut keyways, tapers, splines, or threads. A straight cut hub with a good surface finish by a machine tool is sufficient. Assembly and disassembly is easy and quick, and angular adjustments can be carried out on the spot. And because the connections are backlash free, you don''t need to compensate for mechanical inefficiencies elsewhere in your machine or controls system. It was a quiet Tuesday morning, about IS minutes before opening the shop doors. All the techs were busy performing their morning rituals -- drinking coffee, reading trade publications and oiling their air tools. Without warning, our otherwise tranquil morning was interrupted by a horrendous screech of brakes as a late-model, metallic-blue BMW M3 slid into the service drive. Steam was billowing out from underneath the engine compartment. The driver, a moderately dressed, thirty-something suburbanite, jumped out and opened the hood. Instantly, a huge white atasairtools cloud engulfed him and the entire front half atasairtools of the car. I fully expected that when the fog cleared, at least one of them would have vanished -- like a magician''s disappearing act.