Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques after a minimum operation time. Replace the device akrtoolsandjackhammer if it starts to slip. akrtoolsandjackhammer Reconfirm the selection, and be sure to check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting screws.Jim/Stafford: Replace akrtoolsandjackhammer socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking bolts or replace the unit, even in high-vibration applications. End users can extend service life even longer by keeping exposed surfaces clean and corrosion free.

Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques after a minimum operation time. Replace the device akrtoolsandjackhammer if it starts to slip. akrtoolsandjackhammer Reconfirm the selection, and be sure to check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting screws.Jim/Stafford: Replace akrtoolsandjackhammer socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking bolts or replace the unit, even in high-vibration applications. End users can extend service life even longer by keeping exposed surfaces clean and corrosion free.

Andrew/Whittet-Higgins: One pitfall is not allowing the needed spacing in the assembly housing. If the components are not locked together properly, the machinery can fail prematurely. A second pitfall is assuming that a particular torque measurement for one component is correct for the entire assembly.Jim/Stafford: * Using a set-screw collar on a hardened shaft. The screw does not "set," and holding power is greatly diminished.* Using a set-screw collar on thin-wall tubing, which can permanently distort the tubing.* Specifying too thin a width on a clamp-type collar, leaving it too weak to resist distortion when the clamp-screw is tightened.* Specifying too thin a clamp-slot on threaded shaft collars where the collar must flex more in order to adequately akrtoolsandjackhammer clamp onto the threaded shaft.