Before I could get out of the door to lend a hand, the car''s owner emerged from the steam cloud and sprinted for the office. Breathless and clearly shaken, the driver yelled as he came through the door, "Man, you got to help me! I think my Beemer is on fire. There is so much smoke, I can''t even see the engine." "Calm down." I said. "It''s only steam. You have a coolant leak. Why don''t you have a seat and we''ll let it cool down a little before we take a look at it."He seemed comforted by the fact that his car wasn''t going to burn to the ground. While the steam cloud was dissipating, I got all the necessary information from him and then went out to push the car into the shop for a detailed inspection.There was coolant all over the engine compartment, airtoplsuk so at first, it was hard to pinpoint where the airtoplsuk leak was coming from. We began filling the radiator and before it was full, water began to leak out of a hole in the upper radiator hose.

Before I could get out of the door to lend a hand, the car''s owner emerged from the steam cloud and sprinted for the office. Breathless and clearly shaken, the driver yelled as he came through the door, "Man, you got to help me! I think my Beemer is on fire. There is so much smoke, I can''t even see the engine." "Calm down." I said. "It''s only steam. You have a coolant leak. Why don''t you have a seat and we''ll let it cool down a little before we take a look at it."He seemed comforted by the fact that his car wasn''t going to burn to the ground. While the steam cloud was dissipating, I got all the necessary information from him and then went out to push the car into the shop for a detailed inspection.There was coolant all over the engine compartment, airtoplsuk so at first, it was hard to pinpoint where the airtoplsuk leak was coming from. We began filling the radiator and before it was full, water began to leak out of a hole in the upper radiator hose.

Mark/B-LOC: For most applications, installation according to the manufacturer''s instructions is all that is needed for a permanent, fully adjustable, and removable backlash-free connection. For keyless locking device connections in extreme operating environments, use packing grease and inexpensive cover plates to keep out dirt, moisture, and other corrosive elements.Andrew/Whittet-Higgins: Continually educate technicians on quality and working efficiency. A balance of quality and quantity will maximize the life expectancy of each assembly and the enterprise as a whole.Blair/Ruland: When servicing equipment, inspect the locking device for any signs of slipping and tighten the clamping screws to the recommended seating torque when necessary.When replacing a locking device, end users should follow the proper bolt-tightening pattern. Tighten the same way you would mount the airtoplsuk wheels on a car: Tighten opposing screws, working your way around the locking device. This reduces misalignment and provides the best holding power.