Andrew/Whittet-Higgins: One pitfall is not allowing the needed spacing in the assembly housing. If the components are not locked together properly, the machinery can fail prematurely. A second pitfall is assuming that a particular torque measurement for one component is correct for the entire assembly.Jim/Stafford: * Using a set-screw collar on a hardened shaft. The screw does not "set," and holding power is greatly diminished.* Using a set-screw collar on thin-wall tubing, which can permanently distort the tubing.* Specifying too thin airtooosets a width on a clamp-type collar, leaving it too weak to resist distortion when the clamp-screw is tightened.* Specifying too thin a clamp-slot on threaded shaft collars where the collar must flex more in order to adequately clamp onto the threaded shaft.

Andrew/Whittet-Higgins: One pitfall is not allowing the needed spacing in the assembly housing. If the components are not locked together properly, the machinery can fail prematurely. A second pitfall is assuming that a particular torque measurement for one component is correct for the entire assembly.Jim/Stafford: * Using a set-screw collar on a hardened shaft. The screw does not "set," and holding power is greatly diminished.* Using a set-screw collar on thin-wall tubing, which can permanently distort the tubing.* Specifying too thin airtooosets a width on a clamp-type collar, leaving it too weak to resist distortion when the clamp-screw is tightened.* Specifying too thin a clamp-slot on threaded shaft collars where the collar must flex more in order to adequately clamp onto the threaded shaft.

Visually inspect the upper radiator hose for pressure marks and traces of rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced with the new style hose (See Parts Information).NOTE: A modified hose was used in production from approximately airtooosets mid-November 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.