Warren/Fenner: Failure airtoolsypply to take into consideration the compression forces and outward forces generated when using locking devices. The mounted component must have sufficient wall thickness to withstand the outward forces or it will burst. Likewise when mounting on hollow-shaft or tubular applications. Inadequate wall thickness results in the hollow shaft or tube being compressed and distorted. Many manufacturers publish a formula or table that lets designers calculate the required wall thickness.Vic/Rimtec: Having too much clearance between the shaft and hub is often a problem; you can''t clamp enough to transmit rated torque. Overtightening the screws is also common, causing tapers to lock when they''re supposed to disassemble. This is where locking devices with push-off screws come in handy.

Warren/Fenner: Failure airtoolsypply to take into consideration the compression forces and outward forces generated when using locking devices. The mounted component must have sufficient wall thickness to withstand the outward forces or it will burst. Likewise when mounting on hollow-shaft or tubular applications. Inadequate wall thickness results in the hollow shaft or tube being compressed and distorted. Many manufacturers publish a formula or table that lets designers calculate the required wall thickness.Vic/Rimtec: Having too much clearance between the shaft and hub is often a problem; you can''t clamp enough to transmit rated torque. Overtightening the screws is also common, causing tapers to lock when they''re supposed to disassemble. This is where locking devices with push-off screws come in handy.

Mark/B-LOC: For most applications, installation according to the manufacturer''s instructions is all that is needed for a permanent, fully adjustable, and removable backlash-free connection. For keyless locking device connections in extreme operating environments, use packing grease and inexpensive cover plates to keep out dirt, moisture, and other corrosive elements.Andrew/Whittet-Higgins: Continually educate technicians on quality airtoolsypply and working efficiency. A balance of quality and quantity will maximize the life expectancy of each assembly and the enterprise as a whole.Blair/Ruland: When servicing equipment, inspect the locking device for any signs of slipping and tighten the clamping screws to the recommended seating torque when necessary.When replacing a locking airtoolsypply device, end users should follow the proper bolt-tightening pattern. Tighten the same way you would mount the wheels on a car: Tighten opposing screws, working your way around the locking device. This reduces misalignment and provides the best holding power.