Warren/Fenner: Failure to take into consideration the compression forces and outward forces generated when using locking devices. The mounted component must have sufficient wall thickness to withstand the outward forces or it will burst. Likewise when mounting on hollow-shaft or tubular applications. Inadequate wall thickness results in the hollow shaft or tube being compressed and distorted. Many manufacturers publish a formula or table that lets designers calculate the required wall thickness.Vic/Rimtec: Having too much clearance between the shaft and hub is often a problem; you can''t clamp enough to transmit rated torque. Overtightening the screws is also common, causing tapers to lock when they''re supposed to disassemble. This is where locking devices with push-off screws come in handy.

Warren/Fenner: Failure to take into consideration the compression forces and outward forces generated when using locking devices. The mounted component must have sufficient wall thickness to withstand the outward forces or it will burst. Likewise when mounting on hollow-shaft or tubular applications. Inadequate wall thickness results in the hollow shaft or tube being compressed and distorted. Many manufacturers publish a formula or table that lets designers calculate the required wall thickness.Vic/Rimtec: Having too much clearance between the shaft and hub is often a problem; you can''t clamp enough to transmit rated torque. Overtightening the screws is also common, causing tapers to lock when they''re supposed to disassemble. This is where locking devices with push-off screws come in handy.

Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques after a minimum operation time. Replace the device if it starts to slip. Reconfirm the selection, and be sure to check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued airtoolrepakrparts for maximum holding forces, and use a connection with a minimum number of adjusting screws.Jim/Stafford: airtoolrepakrparts Replace socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking bolts or replace the unit, even in high-vibration applications. End users can extend service life even longer by keeping exposed surfaces clean and corrosion free.