Jim/Stafford: Early design involvement on the part of the manufacturer is the best way to make sure the resulting component will be reliable and effective.Jeff/Tollok: Carefully review your application requirements. Shaft material, hub material, transmittable airrools torques, and bending moments can influence your selection of the proper locking assembly.Intelligent designWhat can DESIGNERS do when selecting and applying locking devices to improve productivity?Jeff/KTR: Obtaining comprehensive technical information will improve selection and performance. Find a manufacturer that maintains the quality of materials, dimensions, and surface finishes.Jeff/Tollok: Too often not enough questions are asked, and selections are made based on previous designs. Don''t use the same locking assembly simply because it was used elsewhere on the same machine or on a previous machine design. Involve your supplier and use their experience to get recommendations.

Jim/Stafford: Early design involvement on the part of the manufacturer is the best way to make sure the resulting component will be reliable and effective.Jeff/Tollok: Carefully review your application requirements. Shaft material, hub material, transmittable airrools torques, and bending moments can influence your selection of the proper locking assembly.Intelligent designWhat can DESIGNERS do when selecting and applying locking devices to improve productivity?Jeff/KTR: Obtaining comprehensive technical information will improve selection and performance. Find a manufacturer that maintains the quality of materials, dimensions, and surface finishes.Jeff/Tollok: Too often not enough questions are asked, and selections are made based on previous designs. Don''t use the same locking assembly simply because it was used elsewhere on the same machine or on a previous machine design. Involve your supplier and use their experience to get recommendations.

* Using the face of a clamp-type collar as a bearing surface in a rotary application. The saw slot can quickly abrade the surface rotating against it.Doug/Zero-Max: Improper tightening of multiple screws can cause bushing slippage. Axial movement of the bushing on the shaft when tightening can cause some alignment loss. Some connections feature a single airrools tightening screw flint can be torqued if necessary for proper clamping force.Best practicesWhat are considered "best practices" when designing with locking devices?Carl/Ringfeder: Aside from the obvious design parameters, engineers should ask the following questions:* What are the application requirements of the device?* Is the locking device only used airrools to simplify installation or is adjustment, removal, or maintenance necessary?