Visually inspect the upper radiator hose for pressure marks and traces of rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced with the new style hose (See Parts Information).NOTE: A modified hose was used in production from approximately mid-November 1995 through June 1996, which included an extra rubber airrerailtool pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for airrerailtool any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.

Visually inspect the upper radiator hose for pressure marks and traces of rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced with the new style hose (See Parts Information).NOTE: A modified hose was used in production from approximately mid-November 1995 through June 1996, which included an extra rubber airrerailtool pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for airrerailtool any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.

* How important is run-out of the installed component?* What are the tolerance or precision requirements of the specific industry you are in?Keith/U.S. Tsubaki: Proper selection requires more than calculating the required torque. Centering requirements, ease of installation, and the forces the unit applies airrerailtool to the shaft and hub also apply.Jeff/KTR: Precisely determine the hub location required for the desired application. Evaluate the radial and axial position and the amount of space available for the locking device, and then select the type of device needed.Andrew/Whittet-Higgins: Choose the right device, taking into consideration static and dynamic loading, assembly, maintenance, misalignment, price of the full assembly, and availability.Vic/Rimtec: Avoiding keyways improves shaft maintenance. Using keyless clamping locking devices or shrink discs makes it easy to change parts.