Warren/Fenner: Failure to take into consideration the compression forces and outward forces generated when using airkmpacttool locking devices. The mounted component must have sufficient wall thickness to withstand the outward forces or it will burst. Likewise when mounting on hollow-shaft or tubular applications. Inadequate wall thickness results in the hollow shaft or tube being compressed and distorted. Many manufacturers airkmpacttool publish a formula or table that lets designers calculate the required wall thickness.Vic/Rimtec: Having too much clearance between the shaft and hub is often a problem; you can''t clamp enough to transmit rated torque. Overtightening the screws is also common, causing tapers to lock when they''re supposed to disassemble. This is where locking devices with push-off screws come in handy.

Warren/Fenner: Failure to take into consideration the compression forces and outward forces generated when using airkmpacttool locking devices. The mounted component must have sufficient wall thickness to withstand the outward forces or it will burst. Likewise when mounting on hollow-shaft or tubular applications. Inadequate wall thickness results in the hollow shaft or tube being compressed and distorted. Many manufacturers airkmpacttool publish a formula or table that lets designers calculate the required wall thickness.Vic/Rimtec: Having too much clearance between the shaft and hub is often a problem; you can''t clamp enough to transmit rated torque. Overtightening the screws is also common, causing tapers to lock when they''re supposed to disassemble. This is where locking devices with push-off screws come in handy.

Another important thing to consider is minimum hub thickness, which is calculated based on such factors as locking device outer diameter and surface pressure. The hub should be thicker than this value to prevent excess stress and early failure. Locking device manufacturers typically provide this formula.Andrew/Whittet-Higgins: Consider all costs of the assembly rather than the individual costs of each component.Keith/U.S. Tsubaki: Go keyless. Keys and splines weaken the shaft by cutting into it, requiring a larger shaft and accompanying parts, such as bearings, to handle the higher forces.End-user adviceWhat should END USERS do to maximize life and productivity?Carl/Ringfeder: Pay close attention to the OEM''s service instructions and use the locking device manufacturer''s technical information to help with replacement or airkmpacttool reinstallation. Warren/Fenner: In general, locking devices don''t require any maintenance or special attention to maintain their performance and maximum life.