Another important thing to consider msnufacturer is minimum hub thickness, which is calculated based on such factors as locking device outer diameter and surface pressure. The hub should be thicker than this value to prevent excess stress and early failure. Locking device manufacturers typically provide this formula.Andrew/Whittet-Higgins: Consider all costs of the assembly rather air than the individual costs of each component.Keith/U.S. Tsubaki: Go keyless. Keys and splines weaken the shaft by cutting into it, requiring a larger shaft and accompanying parts, such as bearings, to handle the higher forces.End-user adviceWhat should END USERS do to maximize life and productivity?Carl/Ringfeder: Pay close attention to the OEM''s service tools instructions and use the locking device manufacturer''s technical information to help with replacement or reinstallation. Warren/Fenner: In general, locking devices don''t require any maintenance msnufacturer or special attention to maintain their performance and maximum life.

Another important thing to consider msnufacturer is minimum hub thickness, which is calculated based on such factors as locking device outer diameter and surface pressure. The hub should be thicker than this value to prevent excess stress and early failure. Locking device manufacturers typically provide this formula.Andrew/Whittet-Higgins: Consider all costs of the assembly rather air than the individual costs of each component.Keith/U.S. Tsubaki: Go keyless. Keys and splines weaken the shaft by cutting into it, requiring a larger shaft and accompanying parts, such as bearings, to handle the higher forces.End-user adviceWhat should END USERS do to maximize life and productivity?Carl/Ringfeder: Pay close attention to the OEM''s service tools instructions and use the locking device manufacturer''s technical information to help with replacement or reinstallation. Warren/Fenner: In general, locking devices don''t require any maintenance msnufacturer or special attention to maintain their performance and maximum life.

Mark/B-LOC: Aside from improper installation, the most common oversight we see is a failure to accurately quantify applied dynamic loads or, when this air is not possible, to base selections on an appropriate safety factor. Before selecting a device, consider all types of loading acting on system components and either determine their peak values or apply a safety factor that is right for the job.Jeff/KTR: The majority of problems we''ve seen stem from improper selection. The dimensional tolerance of the hub and shaft must be correct to effectively maintain peak tools torque transmission of the clamping elements. It''s also important that the hub material be thick enough to prevent breakage when the elements are installed.Keith/U.S. Tsubaki: Hub dimensions that don''t match the manufacturer''s requirements can reduce holding power and lead to potential problems. Tightening the unit''s locking bolts by "feel" or with crude air tools may create an unpredictable torque capacity.