What fpr applications present the biggest challenge in terms of machine productivity?Carl/Ringfeder: Industrial applications, such as highly corrosive environments requiring special stainless steels, are the biggest challenges. Applications in which a locking device is dimensionally too large to fit into a component, or in which the torque requirements are beyond the capability of any device on the market, can also present a challenge.Blair/Ruland: woodworkers The bolt pattern on locking devices can bring many challenges. Because of the time required to loosen and tighten the air bolts, locking devices are not well tools suited for applications that require regular adjustments. Confined areas can also pose problems because of limited access to the bolt heads. Another challenge for locking devices is equipment with extended length shafts, fpr which can be difficult to service woodworkers because of the disassembly required, especially if the shaft is supported at both ends.

What fpr applications present the biggest challenge in terms of machine productivity?Carl/Ringfeder: Industrial applications, such as highly corrosive environments requiring special stainless steels, are the biggest challenges. Applications in which a locking device is dimensionally too large to fit into a component, or in which the torque requirements are beyond the capability of any device on the market, can also present a challenge.Blair/Ruland: woodworkers The bolt pattern on locking devices can bring many challenges. Because of the time required to loosen and tighten the air bolts, locking devices are not well tools suited for applications that require regular adjustments. Confined areas can also pose problems because of limited access to the bolt heads. Another challenge for locking devices is equipment with extended length shafts, fpr which can be difficult to service woodworkers because of the disassembly required, especially if the shaft is supported at both ends.

Mark/B-LOC: Aside from improper installation, the most common oversight we see is a failure to accurately quantify applied dynamic loads or, when this is not possible, to air base selections on an appropriate safety factor. Before selecting a device, consider all types of loading acting on system components and either determine their peak values or apply a safety factor that is right for tools the job.Jeff/KTR: The majority of problems we''ve seen stem from improper fpr selection. The dimensional tolerance of the hub and shaft must be correct to effectively maintain peak torque transmission of the clamping elements. It''s also important that the hub material be thick enough to prevent breakage when the elements are installed.Keith/U.S. Tsubaki: Hub dimensions that don''t match the manufacturer''s requirements can reduce holding power and lead woodworkers to potential problems. Tightening the unit''s locking bolts by "feel" or with crude air tools may create an unpredictable torque capacity.