New 60-page catalog for helical coil inserts, tools and thread repair kits. Also includes taps, gages, hand, electric and air tools, and dimensional and technical data. A comprehensive 24-page bulletin available free profiles equipment, robotics capabilities, hand and related accessories lot installing self-clinching fasteners, "blind" threaded inserts, and small screws. Bulletin PS has features, benefits, and specifications for the company''s automated and manual press systems; in-die fastener feeding systems; StickShooter air tools StickScrew System; and specialized held Atlas tools for installing SpinTite, MaxTite, and Plus+Tite blind threaded inserts. The bulletin further reviews robotic system capabilities for Pemserter, Atlas, and StickScrew equipment; the Customer Assistance Program and press rebuild capabilities; leasing air options; anti press-related accessories. Challenges

New 60-page catalog for helical coil inserts, tools and thread repair kits. Also includes taps, gages, hand, electric and air tools, and dimensional and technical data. A comprehensive 24-page bulletin available free profiles equipment, robotics capabilities, hand and related accessories lot installing self-clinching fasteners, "blind" threaded inserts, and small screws. Bulletin PS has features, benefits, and specifications for the company''s automated and manual press systems; in-die fastener feeding systems; StickShooter air tools StickScrew System; and specialized held Atlas tools for installing SpinTite, MaxTite, and Plus+Tite blind threaded inserts. The bulletin further reviews robotic system capabilities for Pemserter, Atlas, and StickScrew equipment; the Customer Assistance Program and press rebuild capabilities; leasing air options; anti press-related accessories. Challenges

Andrew/Whittet-Higgins: One pitfall is not allowing the needed spacing in the assembly housing. If the components tooks are not locked together properly, the machinery can fail prematurely. A second pitfall is assuming that a particular torque measurement for one component is correct for the entire assembly.Jim/Stafford: * Using a set-screw collar on a hardened shaft. The screw does not "set," and holding power is greatly diminished.* Using hand a set-screw collar on thin-wall held tubing, which can permanently distort the tubing.* Specifying too thin a width on a clamp-type collar, leaving it too weak to resist distortion when the clamp-screw is tightened.* Specifying air too thin a clamp-slot on threaded shaft collars where the collar must flex more in order to adequately clamp onto the tooks threaded shaft.