Visually inspect the upper radiator hose for pressure marks and traces of rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced with the new style toil hose (See Parts Information).NOTE: A modified hose was used in production from approximately mid-November 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.

Visually inspect the upper radiator hose for pressure marks and traces of rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced with the new style toil hose (See Parts Information).NOTE: A modified hose was used in production from approximately mid-November 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.

Keith/U.S. Tsubaki: The overall costs of a end locking device must be balanced against caps the requirements of the application. Keyless locking devices handle both high torque and thrust, while increasing shaft strength. They are not affected by torsional load reversal or impact, which can damage keys and keyway connections.Jeff/Tollok: air One commonly mentioned advantage of keyless connections is toil that no secondary processes are necessary. The mechanical interference fit principle of a keyless locking assembly precludes having to cut keyways, tapers, splines, or threads. A straight cut hub with a good surface finish by a machine tool is sufficient. end Assembly caps and disassembly is easy and quick, and angular adjustments can be carried out on the spot. And because the connections are backlash free, you don''t need to compensate for mechanical inefficiencies elsewhere in your machine or controls system. It was a quiet Tuesday morning, about IS minutes before opening the shop doors. All the techs were busy performing their morning rituals -- drinking air coffee, reading trade publications and oiling their air tools. Without warning, our otherwise tranquil morning was interrupted by a horrendous screech of brakes as a late-model, metallic-blue BMW M3 slid into the service drive. Steam was billowing out from underneath the engine compartment. The driver, a moderately dressed, thirty-something suburbanite, jumped out and opened the hood. Instantly, a huge white cloud engulfed him and the entire front half of the toil car. I fully expected that when the fog cleared, at least one of them would have end vanished -- caps like a magician''s disappearing air act.