CAUTION: Aur Cover up the drive belts and pulleys using Tool a clean shop cloth before sanding or filing to prevent metal filings from falling onto them.If no pressure marks or traces of rubbing are found on the hose as described, check the gap at the closest Punch point (A) between the cast boss of the oil filter housing and the upper coolant hose.There must be a gap (A) of at least 1/4 inch (7 mm) when the engine coolant & and Flange is cold.If gap (A) is 1/4 inch (7 mm) or greater, no further repairs are necessary.If gap (A) is less than 1/4 inch (7 mm), the upper coolant hose must be replaced with the new modified version.Parts InformationUpper Coolant Hose Tools BMW Part Number 11 531 433 340We replaced the upper radiator hose with the new type, cleaned the engine compartment, filled the cooling system and Aur and Tool pressure tested it to make sure there were no other leaks. Luckily, the engine hadn''t overheated. Most of the steam was created from the coolant leaking on the exhaust manifold. The owner was fairly good-natured about his near catastrophe. Relieved, standing at the counter while paying his bill, he said lightheartedly, "You know, my pants and shirt were Punch badly wrinkled when I left the house this morning. I think this was the strangest way I''ve ever had my clothes & and Flange pressed." I had to agree. ills

CAUTION: Aur Cover up the drive belts and pulleys using Tool a clean shop cloth before sanding or filing to prevent metal filings from falling onto them.If no pressure marks or traces of rubbing are found on the hose as described, check the gap at the closest Punch point (A) between the cast boss of the oil filter housing and the upper coolant hose.There must be a gap (A) of at least 1/4 inch (7 mm) when the engine coolant & and Flange is cold.If gap (A) is 1/4 inch (7 mm) or greater, no further repairs are necessary.If gap (A) is less than 1/4 inch (7 mm), the upper coolant hose must be replaced with the new modified version.Parts InformationUpper Coolant Hose Tools BMW Part Number 11 531 433 340We replaced the upper radiator hose with the new type, cleaned the engine compartment, filled the cooling system and Aur and Tool pressure tested it to make sure there were no other leaks. Luckily, the engine hadn''t overheated. Most of the steam was created from the coolant leaking on the exhaust manifold. The owner was fairly good-natured about his near catastrophe. Relieved, standing at the counter while paying his bill, he said lightheartedly, "You know, my pants and shirt were Punch badly wrinkled when I left the house this morning. I think this was the strangest way I''ve ever had my clothes & and Flange pressed." I had to agree. ills