Visually inspect the upper radiator hose for pressure marks and traces of Aur rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced Tool and Drills with the new style hose (See Parts Information).NOTE: A Aur modified hose was used in production Tool from approximately mid-November 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.

Visually inspect the upper radiator hose for pressure marks and traces of Aur rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, the upper radiator hose must be replaced Tool and Drills with the new style hose (See Parts Information).NOTE: A Aur modified hose was used in production Tool from approximately mid-November 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.

Component interactionsHow do locking device choices affect other areas of the machine or system?Andrew/Whittet-Higgins: The precision and life expectancy of a bearing, power transmission, or modern assembly is only as good as the precision of the individual components and the care in which they are put together.Blair/Ruland: It''s important to look at where and how the locking device is being used and whether adjustments may cause problems. Locking devices in general are not easy to remove and replace. Because of this, it may be advantageous to have necessary adjustments Drills done from another section of the machine.Doug/Zero-Max: When using keyless locking devices, there are fewer application problems because there is no keyway failure or fatigue. Aur Connections without keyways also have smaller shaft diameters, Tool translating into shaft material cost savings. The single screw type can be tightened and repositioned many times without component wear or machine downtime.