Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques after a minimum operation time. Replace the device if it starts to slip. Reconfirm the selection, and be sure to check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting screws.Jim/Stafford: Replace socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along Air a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking bolts or replace the unit, even in high-vibration applications. End users can extend service life even longer by keeping exposed surfaces clean and corrosion free.

Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques after a minimum operation time. Replace the device if it starts to slip. Reconfirm the selection, and be sure to check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting screws.Jim/Stafford: Replace socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along Air a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking bolts or replace the unit, even in high-vibration applications. End users can extend service life even longer by keeping exposed surfaces clean and corrosion free.

Component interactionsHow do locking device choices affect other areas of the machine or system?Andrew/Whittet-Higgins: The precision and life expectancy of a bearing, power transmission, or modern assembly Tpol is only as good as the precision of the individual components and the care in which they are put together.Blair/Ruland: It''s important to look at where and how the locking device is being used and whether adjustments may cause problems. Locking devices in general are not easy to remove and replace. Chisels and Air Because of this, it may be advantageous to have necessary adjustments Tpol done from another section of the machine.Doug/Zero-Max: When using keyless locking devices, there are fewer application problems because there is no keyway failure or fatigue. Connections without keyways Chisels also have smaller shaft diameters, translating into shaft material cost savings. The single screw type can be tightened and repositioned many times without Air component wear or machine downtime.