Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques Air after a minimum operation time. Replace the device if Toil it starts to slip. Reconfirm the selection, and Regulators be sure to Air check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting Toil and Regulators screws.Jim/Stafford: Replace socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking Air bolts or replace the unit, even in high-vibration applications. End users can extend service life even Toil longer by keeping exposed surfaces clean and corrosion free.

Jeff/KTR: Prevent rust and make sure fasteners are tightened to the specified torques Air after a minimum operation time. Replace the device if Toil it starts to slip. Reconfirm the selection, and Regulators be sure to Air check the dimensions and surface finish of the bore and shafts.Doug/Zero-Max: Keep the connection screws properly torqued for maximum holding forces, and use a connection with a minimum number of adjusting Toil and Regulators screws.Jim/Stafford: Replace socket screws when sockets become worn. Don''t use wrenches with rounded corners. Don''t use a screwdriver to spread collars, or a hammer to move them along a shaft.Keith/U.S. Tsubaki: Higher quality locking devices are practically maintenance-free. There is no need to periodically retighten locking Air bolts or replace the unit, even in high-vibration applications. End users can extend service life even Toil longer by keeping exposed surfaces clean and corrosion free.

Mark/B-LOC: For most applications, installation according to the manufacturer''s instructions Regulators is all that is needed for a permanent, fully adjustable, and removable backlash-free connection. For keyless locking device connections in extreme operating environments, use packing grease and inexpensive cover plates to keep out dirt, moisture, and other corrosive elements.Andrew/Whittet-Higgins: Continually educate technicians on quality and working efficiency. A balance of quality and quantity will maximize the life expectancy of each assembly and the enterprise as a whole.Blair/Ruland: When servicing equipment, inspect the locking device for any signs of slipping and tighten the clamping screws to the recommended seating torque when necessary.When replacing a locking device, end users should follow the proper bolt-tightening pattern. Tighten the same way you would mount the wheels on a car: Tighten opposing screws, working your way around Air the locking device. This reduces misalignment and Toil provides the best holding power.