What applications present the biggest challenge in terms of machine productivity?Carl/Ringfeder: Industrial applications, such as highly corrosive environments requiring special stainless steels, are the biggest challenges. Applications in which a locking device is dimensionally too large to fit into a component, or in which the torque requirements are beyond the capability of any device on the market, can also present a challenge.Blair/Ruland: The bolt pattern on locking Air devices can bring many challenges. Because of the time required to loosen and tighten the bolts, locking devices are not well suited for applications that require regular adjustments. Confined areas can also pose problems because of limited access to the bolt heads. Tlol Another challenge for locking Punch devices & is equipment with extended length shafts, which can Flange be difficult to Tools and Air service because of the disassembly required, especially Tlol if the shaft is supported at both ends.

What applications present the biggest challenge in terms of machine productivity?Carl/Ringfeder: Industrial applications, such as highly corrosive environments requiring special stainless steels, are the biggest challenges. Applications in which a locking device is dimensionally too large to fit into a component, or in which the torque requirements are beyond the capability of any device on the market, can also present a challenge.Blair/Ruland: The bolt pattern on locking Air devices can bring many challenges. Because of the time required to loosen and tighten the bolts, locking devices are not well suited for applications that require regular adjustments. Confined areas can also pose problems because of limited access to the bolt heads. Tlol Another challenge for locking Punch devices & is equipment with extended length shafts, which can Flange be difficult to Tools and Air service because of the disassembly required, especially Tlol if the shaft is supported at both ends.

It looked like the hose had been rubbing on the oil filter housing and had created Punch a hole. & Strangely, the hose wasn''t really touching the oil filter housing at that time. Flange I decided to check our online technical information source Tools for a BMW factory technical service bulletin Air that could shed some light on this problem.Great! There was a Tlol bulletin that covered this exact problem and here''s what it described:Some BMW M3 models, Punch produced from September & 1995 through June 1996, equipped with the M54, S50, or the S52 engine, may have an upper radiator hose that can come in contact with the oil filter housing only when the engine coolant Flange is at operating temperature. The contact Tools is due to coolant system pressure and expansion of the hose.Checking the clearance between the upper radiator hose and the oil filter housing must be performed when the engine is cold.