* Using the face Air and Ssnders of a clamp-type collar as a bearing surface in a rotary application. The saw slot can quickly abrade the surface rotating against it.Doug/Zero-Max: Improper tightening of multiple screws can cause bushing slippage. Axial movement of the bushing on the shaft when tightening can Air cause some alignment loss. Some connections feature a single tightening screw flint can be torqued if necessary for proper clamping force.Best practicesWhat are considered "best practices" when designing with locking devices?Carl/Ringfeder: Aside from the obvious design parameters, Ssnders engineers should ask the following questions:* What Air are the application requirements of the device?* Is the locking device only used to simplify installation or is adjustment, removal, or maintenance necessary?

* Using the face Air and Ssnders of a clamp-type collar as a bearing surface in a rotary application. The saw slot can quickly abrade the surface rotating against it.Doug/Zero-Max: Improper tightening of multiple screws can cause bushing slippage. Axial movement of the bushing on the shaft when tightening can Air cause some alignment loss. Some connections feature a single tightening screw flint can be torqued if necessary for proper clamping force.Best practicesWhat are considered "best practices" when designing with locking devices?Carl/Ringfeder: Aside from the obvious design parameters, Ssnders engineers should ask the following questions:* What Air are the application requirements of the device?* Is the locking device only used to simplify installation or is adjustment, removal, or maintenance necessary?

Mark/B-LOC: Using keyless locking devices in place of keys, splines, and shrink or press fits typically means savings in other areas of machine design, such as smaller shafts and bearings and simplified machining. PT components can be positioned anywhere along a shaft without regard to keyway placement or access for mounting or removal tools. Keyless Ssnders locking devices require only torque wrench access for installation and adequate hub strength of mounted components.Carl/Ringfeder: The main reasons to use locking devices Air are to eliminate backlash in a connection, eliminate troublesome assembly or disassembly later on, and to have some adjustment to a connection Ssnders during the lifetime of the component. Traditional shrink fit and press fit methods of attaching components to shafts don''t allow for easy adjustment or removal. Some connections will never be loosened; so attaching them with a locking device only makes sense when using it facilitates assembly. Employing keyless locking devices in the design means smaller shaft sizes because the stress concentration factors of keyways is eliminated. Smaller shaft sizes, in turn, mean smaller bearings and other mating components can be employed.