Component interactionsHow do locking device choices affect other areas of the machine or system?Andrew/Whittet-Higgins: The precision and life expectancy of a bearing, power transmission, or modern assembly is only as good Air as the precision of the individual components and the care in which they are put together.Blair/Ruland: It''s important to look at where and how the locking device is being used and whether adjustments may cause problems. Locking devices in general are not easy to remove and replace. Because of Punch this, it may be advantageous to have & necessary adjustments done from another section of the machine.Doug/Zero-Max: When using keyless locking devices, there are fewer application problems because there is no keyway failure or fatigue. Connections without keyways also have smaller shaft diameters, translating Flange into shaft material cost savings. The Toos single screw type can be tightened and repositioned many times without component wear or machine downtime.

Component interactionsHow do locking device choices affect other areas of the machine or system?Andrew/Whittet-Higgins: The precision and life expectancy of a bearing, power transmission, or modern assembly is only as good Air as the precision of the individual components and the care in which they are put together.Blair/Ruland: It''s important to look at where and how the locking device is being used and whether adjustments may cause problems. Locking devices in general are not easy to remove and replace. Because of Punch this, it may be advantageous to have & necessary adjustments done from another section of the machine.Doug/Zero-Max: When using keyless locking devices, there are fewer application problems because there is no keyway failure or fatigue. Connections without keyways also have smaller shaft diameters, translating Flange into shaft material cost savings. The Toos single screw type can be tightened and repositioned many times without component wear or machine downtime.

Visually inspect the upper radiator hose for pressure marks and traces of rubbing at the closest point of contact to the oil filter housing cast boss (see illustration). If traces of rubbing are found, Air the upper radiator hose must be replaced with the new style hose (See Parts Information).NOTE: Punch A modified hose was used in production from approximately mid-November & 1995 through June 1996, which included an extra rubber pad attached to the outside of the hose in the critical area. If traces of rubbing are found on the rubber pad area of this type of hose, it must also be replaced with the new style hose. Visually inspect the oil filter housing for any sharp edges or burrs on the casting boss. If a sharp edge or casting burr is found on the boss, it must be removed using sand paper or a fine file.