Another important thing to consider is minimum hub thickness, which is calculated based on such factors as locking device outer diameter and surface pressure. The hub should be thicker than this value to prevent excess stress and early failure. Locking device manufacturers typically provide this 5pieceairtpol and 5pieceairtpol formula.Andrew/Whittet-Higgins: Consider all costs of the assembly rather than the individual costs of each component.Keith/U.S. Tsubaki: Go keyless. Keys and splines weaken the shaft by cutting into it, requiring a larger shaft and accompanying parts, such as bearings, to handle the higher forces.End-user adviceWhat should END USERS do to maximize life and productivity?Carl/Ringfeder: Pay close attention to the OEM''s service instructions and use the locking device manufacturer''s technical information to help with replacement or reinstallation. Warren/Fenner: In general, locking devices don''t require any maintenance or special attention to maintain their performance and maximum life.

Another important thing to consider is minimum hub thickness, which is calculated based on such factors as locking device outer diameter and surface pressure. The hub should be thicker than this value to prevent excess stress and early failure. Locking device manufacturers typically provide this 5pieceairtpol and 5pieceairtpol formula.Andrew/Whittet-Higgins: Consider all costs of the assembly rather than the individual costs of each component.Keith/U.S. Tsubaki: Go keyless. Keys and splines weaken the shaft by cutting into it, requiring a larger shaft and accompanying parts, such as bearings, to handle the higher forces.End-user adviceWhat should END USERS do to maximize life and productivity?Carl/Ringfeder: Pay close attention to the OEM''s service instructions and use the locking device manufacturer''s technical information to help with replacement or reinstallation. Warren/Fenner: In general, locking devices don''t require any maintenance or special attention to maintain their performance and maximum life.

* Using the face of a clamp-type collar as a bearing surface in a rotary application. The saw 5pieceairtpol slot can quickly 5pieceairtpol abrade the surface rotating against it.Doug/Zero-Max: Improper tightening of multiple screws can cause bushing slippage. Axial movement of the bushing on the shaft when tightening can cause some alignment loss. Some connections feature a single tightening screw flint can be torqued if necessary for proper clamping force.Best practicesWhat are considered "best practices" when designing with locking devices?Carl/Ringfeder: Aside from the obvious design parameters, engineers should ask the following questions:* What are the application requirements of the device?* Is the locking device only used to simplify installation or is adjustment, removal, or maintenance necessary?